29Mainframe Installation Setup: Task 1A - Configuring the Host
Task 1A -
Configuring the
Host
The Mainframe software must support TCP/IP and extended Telnet
protocols to print SCS jobs to a LAN attached printer. “Mainframe
Software” on page 277 lists versions which support these protocols.
TIP:
How to define an LU-1 printer in VTAM is
described in IBM's VTAM documentation.
The printer with the SCS/TNe Emulation is defined to the host like a
normal LU-1 (SCS) printer. Three sample configurations follow.
Sample Configuration number 1:
Remote Device - Line definition In VTAM NCP
* LNACC=SDLC
*¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤
*SDLC SWLINE GROUP
*¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤
G14SD4 GROUP LNCTL=SDLC,TYPE=NCP,OWNER=PCCU1,
NRZI=NO,REPLYTO=2, DIAL=YES
S14535 LINE ADDRESS=(2535,Half),SPEED=9600,
TRANSFR=20, DUPLEX=FULL,NEWSYNC=NO,
CLOCKNG=EXT, NPACOLL=YES, LSPRI=NO,
RETRIES=(1,1,3),ISTATUS=ACTIVE,MAXPU=1,
OWNER=PCCU1,TYPE=NCP,CALL=IN,ANSWER=ON
*CU= NR=1 ACT=13 TRM=YES
P1453500PU PUTYPE=(1,2), NPACOLL=YES
To Next Page
Loading...
