Lexmark X644E - Task 1 - Configuring the Host

54AS/400 and iSeries Installation Setup: Task 1 - Configuring the Host
Task 1 -
Configuring the
Host
The host operating system must support TCP/IP and extended Tel-
net protocols to print SCS jobs to a LAN attached printer.
Section “AS/400 and iSeries Software” on page 277 lists host soft-
ware which supports these protocols.
To configure the host check and set the following three system
values.
System Value Required Value
QAUTOCFG Controls the automatic configuration of devices.
Must be set to '1'
Sample commands:
DSPSYSVAL SYSVAL(QAUTOCFG)
CHGSYSVAL SYSVAL(QAUTOCFG) VALUE('1')
QAUTORMT Controls the automatic configuration of remote
controllers.
Must be set to '1'
Sample commands:
DSPSYSVAL SYSVAL(QAUTORMT)
CHGSYSVAL SYSVAL(QAUTORMT) VALUE('1')