Lexmark X644E - Task 1 B - Configuring the Host for Printing Via a SNA Server

33Mainframe Installation Setup: Task 1B - Configuring the Host for Printing via a SNA Server
Task 1B -
Configuring the
Host for Printing
via a SNA Server
The printer with the SCS/TNe Emulation is defined to the host like a
normal LU-1 (SCS) printer.
Two sample configurations are shown below.
TIP:
How to define an LU-1 printer in VTAM is
described in IBM's VTAM documentation.
Sample Configuration number 1
Remote Device - Line definition In VTAM NCP
* LNACC=SDLC
*¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤
*SDLC SWLINE GROUP
*¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤¤
G14SD4 GROUP LNCTL=SDLC,TYPE=NCP,OWNER=PCCU1,
NRZI=NO,REPLYTO=2, DIAL=YES
S14535 LINE ADDRESS=(2535,Half),SPEED=9600,
TRANSFR=20, DUPLEX=FULL,NEWSYNC=NO,
CLOCKNG=EXT, NPACOLL=YES, LSPRI=NO,
RETRIES=(1,1,3),ISTATUS=ACTIVE,MAXPU=1,
OWNER=PCCU1,TYPE=NCP,CALL=IN,ANSWER=ON
*CU= NR=1 ACT=13 TRM=YES
P1453500PU PUTYPE=(1,2), NPACOLL=YES