Lexmark X644E - Page 24

24
IPDS Printer and Host Setup Guide PSF/MVS LAN Printing Using the Standard Network Port or Internal Print Server
Step 2 Define the printer to JES
a) Example for JES2
b) Example for JES3
Step 3 Add the printer to the PSF STARTUP PROC
The value (15) for DISCINTV specifies the time in seconds after which PSF ends the printer session when
no output is available. The valid range is from 0 to 8160 seconds. The default value is 0. If
DISCINTV=0, the
PSF does not end the printer session when no output is available. Refer to
“Printer and Host Timeout Values”
[page 50]
for information on selecting the DISCINTV value.
FSS(FSS1)
PRT7
PROC=PSFPROC,HASPFSSM=HASPFSSM
FSS=FSS1,MODE=FSS,
PRMODE=(LINE,PAGE,SOSI1,SOSI2),
CLASS=C,UCS=0,SEP,NOSEPDS,CKPTPAGE=100,
DRAIN,MARK,TRKCELL=YES
FFSDEF,TYPE=WTR,FSSNAME=FSS3,PNAME=SAMPLE01,
SYSTEM=SYS1,TERM=NO,
DEVICE,DTYPE=PRTAFP1,NAME=PRT7,
JUNIT=(,SYS1,,OFF),FSSNAME=FSS3,
MODE=FSS,PM=(LINE,PAGE,SOSI1,SOSI2),CHARS=(YES,GT12),
CARRIAGE=(YES,A868),CKPNTGP=100,HEADER=YES,
WC=(C)
Add printer to PSFSTARTUP PROC.
Parameters to change are shown in
bold.
// PRT7 CNTL /* */
// PRT7 PRINTDEV FONTDD=*.FONT01, /* FONT */
// OVLYDD=*.OLAY01, /* OVERLAY */
// PSEGDD=*.PSEG02, /* SEGMENT */
// PDEFDD=*.PDEF01, /* PAGEDEF */
// FDEFDD=*.FDEF01, /* FORMDEF */
// JOBHDR=*.JOBHDR /* JOB HEADER */
// JOBTRLR=*.JOBTLR /* JOB TRAILER */
// DSHDR=*.DSHDR, /* DATA SET HEADER */
// FORMDEF=A10110, /* FORMDEF */
// PIMSG=(YES,16), /* MESSAGES */
//
DATACK=UNBLOCK,
/* REPORT ALL DATA CHECKS */
// TRACE=NO, /* INTERNAL TRACE */
//
MGMTMODE=OUTAVAIL,
/* PRINTER MANAGEMENT MODE */
//
CONNINTV=0,
/* NO TIMEOUT */
//
DISCINTV=15,
/* TIMEOUT=15 SECONDS */
//
TIMEOUT=REDRIVE,
/* PSF ACTION ON TIMEOUT */
//
FAILURE=WCONNECT,
/* ATTEMPT RECONNECT */
//
IPADDR='157.184.67.102',
/* IP ADDRESS FOR PRINTER */
//
PORTNO=5001,
/* PORT ADDRESS FOR PRINTER*/
// PRT7 ENDCNTL /* */