33
IPDS Printer and Host Setup Guide MVS Coax Printing Using the Adapter for SCS
Step 7 Define the printer to JES
JES2 Definition Example
JES3 Definition Example
Step 8 Add the printer to the PSF/MVS STARTUP PROC
Step 9 Verify IPDS Printing
If you have completed the steps above to configure the host and printer, you are ready to print your first IPDS
job.
1 Send an IPDS job from your host system.
2 Observe the printer control panel. When the first job data is received, BUSY should be displayed in the
printer control panel. If the job does not print, go to Step
10
Troubleshooting
.
FSSDEF
PRT2
FSSNAME=FSS1,...
FSS=FSS1,Mode=FSS,PRMODE=(LINE,PAGE,SOSI1,SOSI2),
CLASS=B,UCS=0,SEP,NOSEPDS,CKPTPAGE=100, DRAIN,MARK
FSSDEF TYPE=WTR,FSSNAME=FSS2,PNAME=SAMPRO2,SYST4EM=SYS1,TERM=NODEVICE,
DTYPE=PRTAFP1,JNAME=PRT2,JUNIT=(,SYS1,,OFF),FSSNAME=FSS2,MODE=FS
S,PM=(LINE,PAGE,SOSI1,SOSI2),CHARS=(YES,60D8),
CARRIAGE=(YES,A868),CKPNTG=100,HEADER=YES,WC=(B)
Add the printer to the PSF/MVS Startup Proc.
Example PSF STARTUP PROC with parameters to change shown in
bold.
//
//
PRT2 PRINTDEV
FONTDD=*,FONT01,
/*
/*
FONT LIBRARY DD */
*/
// OVLYDD=*,OLAY01, /* OVERLAY LIBARY DD */
// PSEGDD=*,PSEG02, /* SEGMENT LIBRARY DD */
// PDEFDD=*,PDEF01, /* PAGEDEF LIBARY DD */
// FDEFDD=*,FDEF01, /* FORMDEF LIBRARY DD */
// JOBHDR=*,JOBHDR /* JOB HEADER SEPARATOR OUTPUT */
// JOBTRLR=*,JOBTLR /* JOB TRAILER SEPARATOR OUTPUT */
// DSHDR=*,DSHDR, /* DATA SET HEADER SEPARATOR */
// FORMDEF=A10110, /* DEVICE FORMDEF DEFAULT */
// PIMSG=(YES,16), /* ACCUMULATE DATA SET MESSAGES */
//
DATACK=UNBLOCK,
/* REPORT ALL DATA CHECKS */
// TRACE=NO, /* INTERNAL TRACE */
// FAILURE=WCONNECT, /* ATTEMPT RECONNECT */
//
DISCINTV=15,
/* TIMEOUT = 15 SECONDS */
//
TIMEOUT=REDRIVE
/* PSF ACTION ON TIMEOUT */
//
MGMTMODE=OUTAVAIL,
/* PRINTER MANAGEMENT MODE */
//
APPLID=PSFAPP1,
/* VTAM: APPLID OF PSF */
//
LUNAME=SNAT630,
/* VTAM: PRINTER LOGICAL UNIT NAME */
// PRT2 ENDCNTL /* */
To Next Page
Loading...
