Attendance messages
107
Understanding MFP messages
Fax Memory Full There is no memory to complete a fax
job. Any attempted fax jobs are
canceled.
Touch Continue to clear the message.
If restarting job,
replace originals that
have not begun to exit
the scanner.
One or more messages that
interrupted a scan job are now
cleared. A situation exists where a
page is not completely scanned, but
not fully exited the ADF.
Replace the original documents in the scanner
to restart the scan job.
Touch Restart job if page level recovery is
active and the job is restartable. The message
clears. A new scan job containing the same
parameters as the previous job starts.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
Insert staple cartridge The staple cartridge is missing from
the MFP.
Install a staple cartridge to clear the message.
Touch Continue to clear the message and print
without using the staple feature.
Insert tray [x] Occurs when the MFP detects a
missing tray. x can be 1, 2, 3, 4, or 5.
Insert the specified tray to clear the message.
Touch Cancel Job to cancel the current job if
needed.
To u c h Reset Active Bin to change to another
linked bin.
Install bin <x> The MFP detects that bin [x] is
missing where x is the number of the
bin. This message occurs when
pages are formatted when the bin is
present, but before the pages are
printed. Between the formatting and
printing time, the optional bin is
removed from the MFP.
• Turn the MFP off, unplug the power cord from
the wall outlet, install the specified bin,
connect the power cord to a properly
grounded outlet, and then restart the MFP.
•Touch Cancel Job to cancel the current job.
•Touch Reset Active Bin to reset the active
bin for a linked set of bins.
Install duplex The MFP detects that the duplex unit
is missing. This message occurs
when pages are formatted when the
duplex unit is present, but before the
pages are printed. Between the
formatting and printing time, the
duplex unit is removed from the MFP.
• Turn the MFP off, unplug the power cord from
the wall outlet, install the duplex unit, connect
the power cord to a properly grounded outlet,
and then restart the MFP.
•Touch Cancel Job to cancel the current job.
Install envelope feeder The MFP detects that the optional
envelope feeder is missing between
the time the job processes, but before
the job prints. Sometime during
processing, the optional envelope
feeder is removed.
Install the optional envelope feeder. The
message clears.
Touch Cancel Job if needed.
Touch Reset Active Bin to reset the active bin
for a linked set of bins.
Message Meaning Action
To Next Page
Loading...
