4 Close the front door, and then close the top access cover.
5 From the printer control panel, touch Continue, jam cleared.
Paper jam under the photoconductor units
1 Ope the printer top access cover.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
2 Open the front door.
Warning—Potential Damage: To avoid overexposing the photoconductor units, do not leave the front door
open for more than 10 minutes.
3 If lodged under the photoconductor units, then firmly grasp the jammed paper on each side, and then gently pull
it out .
Note: Make sure all paper fragments are removed.
4 If the jammed paper is lodged too tightly under the photoconductor units, then remove the photoconductor units
and place them on a flat surface.
Warning—Potential Damage: Be careful not to touch the photoconductor drum. Doing so may affect the print
quality of future print jobs.
Clearing jams 256
To Next Page
Loading...
