Lexon LL128 - Charging; Padlock Programming

CHARGING
1. Plug the USB cable to a USB charging source (5V output).
2. Plug the end of the USB Type-C plug into the padlock USB Type-C port.
Low battery
Green light flashes each time you touch the fingerprint reader
Charging
Steady Green
Fully charged
Off
Notice: Please do not operate the fingerprint padlock when charging
PADLOCK PROGRAMMING
Factory mode
Any fingerprint can unlock the padlock.
Register Administrator & User accounts
The administrator profile must be registered first before any other profile.
Administrator confirmation is required to add new users.
Notice: Make sure to position your finger properly to avoid hiding the LED indicator located at the
top of the fingerprint reader
Set administrator account
The administrator account will be identified when registering or resetting the user account.
Please ensure your padlock is in standby. The padlock must be locked, and the indicator light off.