541
8-2. Steps to take in an emergency
CT200h_OM_OM76134U_(U)
8
When trouble arises
*
1
: Refer to the separate “Scheduled Maintenance” or “Owner’s Manual Supplement”
for the maintenance interval applicable to your vehicle.
*
2
: For the EV drive mode operating conditions (P. 160).
(U.S.A. only)
Indicates that all maintenance according to the driven
distance on the maintenance schedule
*
1
should be per-
formed soon.
Comes on approximately 4500 miles (7200 km)
after the message has been reset.
If necessary, perform maintenance.
(U.S.A. only)
Indicates that all maintenance is required to correspond
to the driven distance on the maintenance schedule
*
1
.
Comes on approximately 5000 miles (8000 km)
after the message has been reset.
(The indicator will not work properly unless the mes-
sage has been reset.)
Perform the necessary maintenance. Please reset
the message after the maintenance is performed
(P. 4 66)
(If equipped)
Indicates that the pre-collision system is not currently
functional because the grille cover or the sensor is dirty
This message also appears when the pre-collision sys-
tem is not functional due to overheating.
Check the grille cover and the sensor and clean
them if they are dirty.
In case of overheating, the system will become func-
tional once the system cools down.
Indicates that the EV drive mode is not available*
2
The reason the EV drive mode is not available (the
vehicle is idling, battery charge is low, speed is higher
than the EV drive mode operating speed range, accel-
erator pedal is depressed too much) may be dis-
played.
A buzzer also sounds.
Use the EV drive mode when it becomes available.
Indicates that the EV drive mode has been automatically
canceled*
2
The reason the EV drive mode is not available (the
battery charge is low, speed is higher than the EV
drive mode operating speed range, accelerator pedal
is depressed too much) may be displayed.
A buzzer also sounds.
Drive the vehicle for a while.
Warning message Details/Actions
To Next Page
Loading...
