70
EXPLANATION OF MAINTENANCE ITEMS
MAINTENANCE
Scheduled Maintenance Log
Engine Oil and Oil Filter
Replace the oil filter and drain and
refill the engine oil at specified
intervals. SAE 0W-20 oil is the
best choice for good fuel economy
and good starting in cold weather.
If SAE 0W-20 is not available,
SAE 5W-20 may be used; however,
it must be replaced with SAE 0W-20
at the next oil change. See your
Lexus dealer for oil specifically
formulated for your vehicle’s engine.
These models are equipped with a
replaceable oil-filter element and
oil-filter cap O-ring; replace both
at each oil change. For instructions
on how to reset the reminder light,
refer to your Owner’s Manual.
Note: If you do the majority of your
driving under any of the special
operating conditions indicated on
page 44, you should replace the
engine oil and oil filter every six months
or 5,000 miles, regardless of the oil
used or the certification of the vehicle.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes,
muffler and hangers for cracks,
deterioration and damage. Start the
engine and listen carefully for any
exhaust leakage. Tighten connections
and replace parts as necessary.
Fuel Lines and Connections,
Fuel Tank Band and Fuel Tank
Vapor Vent System Hoses
Visually inspect for corrosion,
damage, cracks, and loose or leaking
connections. Tighten connections
and replace parts as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks,
deterio ration and damage
and replace if necessary.
Nuts and Bolts on Chassis
Check that tightness of the seat-
mounting bolts and front/rear
suspension-member retaining bolts
matches torque measurements
specified in the Repair Manual.
Rack-and-Pinion Assembly
Inspect the rack-and-pinion assembly
for signs of leakage, damage and
loose electrical connections. Tighten
connections and if you discover any
leakage or damage, have it repaired
immediately by a qualified technician.
To Next Page
Loading...
