Lexus CT200h - Page 469

469
3-7. Other interior features
3
Interior features
CT200h_U (OM76040U)
■ Programming a rolling code system (for U.S.A. owners)
If your device is rolling code equipped, follow the steps under the
heading “Programming HomeLink
®
” before proceeding with the
steps listed below.
Locate the training button* on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
for the location of the training button
*.
Press the training button*.
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and hold the vehicle’s programmed HomeLink
®
button for
2 seconds and release it. Repeat this step once again. The garage
door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
®
signal and operate the garage door.
Repeat the steps above to program another rolling code system
for any of the remaining HomeLink
®
buttons.
*: Names such as “learn”, “smart” or others vary according to manufac-
turer.
STEP 1
STEP 2
STEP 3
STEP 4