512
7-2. Steps to take in an emergency
GS350_300_GS F_OM_OM30G34U_(U)
■ When adding engine coolant (GS350/GS300)
Add coolant in accordance with the following procedure.
Remove caps A and B.
Add engine coolant through the inlet of cap A up to the “[AR/GR] B” line, and then
install cap A.
Add engine coolant through the inlet of cap B until it is full, and then install cap B.
GS300 only: When installing cap B, apply coolant to the O-ring on the end of cap B.
Cap A
Cap B
“[AR/GR] B” line (Target fill line)
1
2
3
1
2
3
To Next Page
