58
1-6. Theft deterrent system
■ The alarm cannot be set when
In the following situations, the alarm cannot be set. Be careful if the vehicle will not
be used for an extended period of time.
● When a battery terminal is disconnected
● When the “D/C CUT” fuse is removed
■ Canceling and automatic re-enabling of the tilt sensor
● The alarm will still be set even when the tilt sensor is canceled.
● After the tilt sensor is canceled, turning the ignition switch to the “ON” position
or unlocking the doors using the wireless remote control or key will re-enable
the tilt sensor.
● When the alarm system is set again, the intrusion sensor and tilt sensor will be
set.
■ Tilt sensor detection considerations
The sensor may trigger the alarm in the following situations. Cancel the tilt sensor
as necessary.
● The vehicle is transported by a ferry, a flatbed track, train, etc.
● The vehicle is parked in a parking garage.
● Any of the tires loses air pressure.
● The vehicle is jacked up.
● An earthquake occurs or the road caves in.
■ To ensure the system operates correctly
Do not modify or remove the system. If modified or removed, the proper operation
of the system cannot be guaranteed.
To Next Page
Loading...
