51
1-2. Opening, closing and locking the doors and trunk
1
Before driving
■ Setting and canceling the functions
To switch between setting and canceling, follow the procedure below.
Close all the doors and switch the “ENGINE START STOP”
switch to IGNITION ON mode. (Perform the step 2 within 20
seconds.)
Shift the shift lever to “P” or “N”,
and press and hold the driver's
door lock switch ( or ) for
approximately 5 seconds and then
release.
The shift lever and switch positions
corresponding to the desired func-
tion to be set or canceled are
shown as follows:
When the setting or canceling operation is complete, all doors are locked
and then unlocked.
Function Shift lever position Switch position
Shift position linked door locking
function
P
Shift position linked door unlock-
ing function
Speed linked door locking function
N
Driver's door linked door unlocking
function
To Next Page
Loading...
