Lexus NX 200 - Page 89

88
LEXUSNX300/NX200OwnersManualGeneralM78540en
2-1. Instrument cluster
Displays warning messages in case of a malfunction (P.433)
Speedometer
Displays the vehicle speed
Fuel gauge
Displays the quantity of fuel remaining in the tank
Shift position and shift range
Displays the selected shift position or selected shift range (P.177, 181)
Odometer, trip meter and maintenance required information (if equipped) dis-
play
Odometer:
Displays the total distance the vehicle has been driven
Trip meter:
Displays the distance the vehicle has been driven since the meter was last reset. Trip meters
“A” and “B” can be used to record and display different distances independently.
Maintenance required information:
Displays the remaining distance until the engine oil should be changed.
• Displays the maintenance required information when the engine switch is IGNITION
ON mode.
• It can be reset on of the multi-information display. (P.93)
■ Operating condition
The engine switch is in IGNITION ON
mode.
■ Outside temperature display
● In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change.
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
● When “--” or “E” is displayed, the system
may be malfunctioning.
Take your vehicle to your Lexus dealer.
■ Pop-up display
In some situations, a pop-up display will be
temporarily displayed on the multi-informa-
tion display or the odometer/trip
meter/maintenance required information
screen. The pop-up display function can be
set on/off. (P.95)
■ Liquid crystal display
Small spots or light spots may appear on the
display. This phenomenon is characteristic
of liquid crystal displays, and there is no
problem continuing to use the display.
■ Customization
The meter display can be customized on
the multi-information display. (Customiz-
able features: P.482)
G
H
I
J