Lexus NX 200 - Page 92

91
2
LEXUSNX300/NX200OwnersManualGeneralM78540en
2-1. Instrument cluster
Vehicle status information and indicators
displayed screen to
The registration confirmation screen is dis-
played. If the selected screen cannot be
registered, a registration failure message
will be shown.
Call sending/receiving and history
display
Linked with the hands-free system, sending
or receiving call is displayed. For details
regarding the hands-free system, refer to
the “Navigation and Multimedia System
Owner’s Manual”.
■ Content displayed as drive infor-
mation
Select to display various drive data.
Up to 2 of the following items can be
selected.
Items displayed can be switched by
pressing or of the meter con-
trol switches to select and pressing
or .
 Current fuel consumption
*1
Displays the current rate of fuel consump-
tion
 Average fuel consumption (after
reset
*2
/after start/after refuel)
*1
Displays the average fuel consumption
since the function was reset, the engine
was started, and the vehicle was refueled,
respectively
Use the displayed average fuel consump-
tion as a reference.
 Average vehicle speed (after
reset
*2
/after start)
*1
Displays the average vehicle speed since
the function was reset and the engine was
started, respectively
 Elapsed time (after reset
*2
/after
start)
*1
Displays the elapsed time since the func-
tion was reset and the engine was started,
respectively
 Distance (driving range/after start)
*1
Displays the estimated maximum distance
that can be driven with the quantity of fuel
remaining and the distance driven after the
engine was started respectively.
• This distance is computed based on your
average fuel consumption. As a result,
the actual distance that can be driven
may differ from that displayed.
• When only a small amount of fuel is
added to the tank, the display may not be
updated.
When refueling, turn the engine switch
off. If the vehicle is refueled without turn-
ing the engine switch off, the display may
not be updated.
 Stop & Start system operation time
(after reset
*2
/after start)
Displays the amount of time the engine was
stopped due to operation of the Stop &
Start system.
*1
: Displayed when the item is set in “Drive
Info 1”, “Drive Info 2” and “Drive Info 3”.
*2
: The function can be reset by pressing
the of the meter control switches
for longer than 1 second when the item
to reset is displayed.
Drive information
E