25
19. Select “Accept” on the “Terms of service” screen.
20. The software installation will now begin.
Note: Do NOT turn OFF the engine or ACC BEFORE the software
installation is complete. Do NOT remove the USB storage device until instructed.
21. Once the update is complete the “Software update” pop-up will appear.
22. Select the “OK” icon. The Software Update Procedure is now complete.
Yo u can remove the USB device from the vehicle.
Connect vehicle to a Wi-Fi Network
9
:
1. Park the vehicle within signal range of the desired Wi-Fi network.
2. Select the “Settings” icon in the lower left corner.
3. Select “Data & Wi-Fi.”
4. Select “Wi-Fi.”
5. Turn the Wi-Fi toggle to “ON” (slide to the right).
9
See disclosures on back pages.
SOFTWARE UPDATES
21-LCS-16022 NX TECH GUIDE 10b.indd 25 1/31/22 12:42 PM
To Next Page
Loading...
