274
5-2. Using the air conditioning system
The indicator light comes on when the
heated steering wheel is operating.
■
Operation condition
The engine switch is in IGNITION ON
mode.
■
Timer function
The heated steering wheel will automati-
cally turn off after about 30 minutes.
Vehicles without seat ventilators
Each time the switch is pressed, the
intensity of the seat heater changes
and the level indicator lights (amber)
light as follows:
Hi (3 segments lit)Mid (2 segments
lit)Lo (1 segment lit)Off
Vehicles with seat ventilators
Each time the switch is pressed, the
intensity of the seat heater changes
and the level indicator lights (amber)
light as follows:
Hi (3 segments lit)Mid (2 segments
lit)Lo (1 segment lit)Off
■
Operation condition
The engine switch is in IGNITION ON
mode.
■
Seat heater timer control
To enable seat heater timer control, press
and hold the driver and front passenger
seat heater switches at the same time when
the vehicle is stopped until a buzzer sounds
once. If a seat heater is turned on while seat
heater timer control is enabled, the intensity
of the seat heater will automatically change
from HiMidLo.
The timing of the change in seat heater
intensity differs depending on the tempera-
ture inside the cabin, etc. when the seat
heater is operating.
To disable seat heater timer control, press
and hold the driver and front passenger
seat heater switches at the same time until a
buzzer sounds twice.
Seat heaters
A
■
To prevent overheating and minor
burn injuries
Observe the following precautions when
using the seat heaters.
●
Do not cover the seat with a blanket or
cushion when using the seat heater.
RC350-RC300_OM_General_OM24884E
To Next Page
Loading...
