Lexus RC200T 2016 - Programming Homelink

73
■ Programming HomeLink
®
Press and release the HomeLink
®
button you want to program and check that the
HomeLink
®
indicator light flashes (orange).
Perform within 60 seconds of , or the indicator light will stop flashing and pro-
gramming will not be able to be completed.
Point the remote control transmitter for the
device at the rear view mirror, 1 to 3 in. (25
to 75 mm) from the HomeLink
®
buttons.
Keep the HomeLink
®
indicator light in view
while programming.
For U.S.A. owners
Press and hold the handheld transmitter
button until the HomeLink
®
indicator light
changes from slowly flashing orange to rap-
idly flashing green (rolling code) or continu-
ously lit green (fixed code), then release the
button.
Programming an entry gate (for U.S.A. owners)/Programming a device in the Cana-
dian market
Press and release the remote control transmitter button at 2 second intervals, repeat-
edly, until the HomeLink
®
indicator light changes from slowly flashing (orange) to rap-
idly flashing (green) (rolling code) or continuously lit (green) (fixed code).
Test the HomeLink
®
operation by pressing the newly programmed button and observ-
ing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous, programming has
been completed and your garage door or other device should operate when the
HomeLink
®
button is pressed and released.
● Device with rolling code: If the indicator light flashes rapidly, your garage door
opener motor (or other device) is equipped with a rolling code. Complete the pro-
gramming process by firmly pressing and holding the programmed HomeLink
®
button for 2 seconds and then release the button.
● If the garage door or other device does not operate, proceed to “If your garage
door is of the rolling code type”.
1
3 1
2
3
3
4