115
2. Instrument cluster
2
Instrument cluster
■ Rev indicator (F SPORT models)
Select to set the rev indicator on/off.
When set to on, proceed to set the engine speed at which the rev indicator will
be displayed.
Selectable engine speed range:
RC350/RC300: 2000 rpm to 6600 rpm
RC200t: 2000 rpm to 6100 rpm
■ Rev peak (F SPORT models)
Select to set the rev peak on/off.
■ Speed indicator (F SPORT models)
Select to set the speed indicator on/off.
When set to on, proceed to set the vehicle speed at which the speed indicator
will be displayed.
Selectable speed range:
30 mph to 100 mph (50 km/h to 160 km/h)
*
*: Always observe the legal speed limit when driving on public roads.
■ Initialization
Select to reset the meter display settings. (→P. 674)
■ Suspension of the settings display
In the following situations, operation of the settings display will be temporarily sus-
pended.
● When a warning message appears on the multi-information display
● When the vehicle begins to move
■ Tire pressure
● It may take a few minutes to display the tire inflation pressure after the engine switch is
turned to IGNITION ON mode. It may also take a few minutes to display the tire infla-
tion pressure after inflation pressure has been adjusted.
● “---” may be displayed if the tire information cannot be determined due to unfavorable
radio wave conditions.
● Tire inflation pressure changes with temperature. The displayed values may also be dif-
ferent from the values measured using a tire pressure gauge.
■ When disconnecting and reconnecting battery terminals
The drive information data will be reset.
■ Liquid crystal display
→P. 100
To Next Page
Loading...
Need help?
General
