87
3-1. Basic operation
3
Navigation system
The traveled route can be stored and
retraced on the map screen. This fea-
ture is available when the map scale is
30 miles (50 km) or less.
1 Select on the map screen.
2 Select “Route Trace”.
The route trace starts.
3 Check that the traveled line is dis-
played.
1 Select on the map screen.
2 Select “Route Trace” again.
3 A confirmation screen will be dis-
played.
“Yes”: Select to keep the recorded route
trace.
“No”: Select to erase the recorded route
trace.
● The traveled route can be stored up to
approximately 621 miles (1000 km).
The map mode on the side display can
be changed.
1 Select or to change the
map mode.
“Map”: Display the single map screen.
“Compass”: Display the compass
mode screen. (P.88)
“Freeway Exit List”: Display the freeway
exit list screen. (P.105)
“Turn List”: Display the turn list screen.
(P.107)
“Turn-by-Turn Arrow”: Display the
turn-by-turn arrow screen. (P.107)
Depending on the conditions, cer-
tain screen configuration buttons
cannot be selected.
Route trace
Start recording the route trace
Stop recording the route trace
Switching the map mode on the
side display