COMFORT ADJUSTMENT
124
16R057
1
Bolt
2
Anchor bracket
3
Spacer
3. Insert a 15 mm (0.6 in.) spacer, and tighten down the anchor
bracket for your child restraint system with a bolt. Torque the bolt
to 16.5 – 24.7 N·m (1.68 –2.52 kgf·m, 12.2 – 18.2 ft·lbf.).
To comply with Canada Motor Vehicle Safety Standards, vehicles
sold in Canada are provided with a bracket set in the glovebox,
designed for use with either of the 2 anchor locations shown in the
illustration.
DRIVING POSITION MEMORY
SYSTEM
The micro computer can memorize the position of the driver’s seat.
Two different driving position profiles can be entered into the
computer’s memory.
Recording a driving position in the computer’s memory can only be
done when the ignition key is in the ”ON” position and the shift lever
is in the ”P” position.
Setting a driving position
16R058a
1. Adjust the driver’s seat to the desired position.
2. While pushing the ”SET” button, push button ”1” or ”2” until
the signal beeps.
The beep sound means that the positions are recorded in the
computer’s memory.
To Next Page
Loading...
