ENGINE
250
Oil identification marks
62L006
API Service Symbol ILSAC Certification Mark
Either or both API registered marks are added to some oil containers
to help you select the oil you should use.
The API Service Symbol is located anywhere on the outside of the
container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SJ. The
center portion of the label shows the SAE viscosity grade such as
SAE 5W–30. ”Energy–Conserving”, shown in the lower portion,
indicates that the oil has fuel–saving capabilities.
The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the
front of the container.
CHECKING THE ENGINE
COOLANT LEVEL
62R004
1
Reservoir cap
2
Upper line
3
Lower line
Park the vehicle at a level spot and look at the see–through
coolant reservoir when the engine is cool. The coolant level is
satisfactory if it is between the upper and lower lines on the tank.
If the level is low, add ethylene–glycol type coolant.
The coolant level in the reservoir will vary with engine coolant
temperature. However, if the level is on or below the lower line, add
coolant to bring the level up to the upper line.
Use only ethylene–glycol type coolant. For information on
ethylene–glycol coolant, see also ”Engine coolant selection”
described below.
If the coolant level drops within a short time after replenishing, there
may be a leak in the system. Visually check the radiator, hoses,
radiator cap, drain cock and water pump.
To Next Page
Loading...
