ELECTRICAL COMPONENTS
334
INFORMATION
If 3 turns of the Phillips−head screwdriver are
appropriate for the vertical movement adjusting bolt
1 (inside screw) at step 1, turn the Phillips−head
screwdriver three fifth turns in the same direction as
step 1 for the vertical movement adjusting bolt 2
(outside screw).
The turning confirmation mark is stamped at the tip
of the vertical movement adjusting bolt 2 (outside
screw). Turn the Phillips−head screwdriver for
turning the vertical movement adjusting bolt 2
(outside screw) while checking this mark.
REPLACING LIGHT BULBS
The illustrations on the following pages show the locations of
light bulbs. If it is necessary to replace a bulb, take your vehicle
to your Lexus dealer as soon as possible. Use bulbs with the
bulb numbers and wattage ratings given in the table.
CAUTION
Do not disassemble, repair or take apart the low beam
headlight bulbs, connector, power supply circuits
and rotated components. Or you may be injured by
electric shocks. Call your dealer when the headlights
fail to work or have to be replaced or disposed of.
To prevent yourself from burning, do not replace the
light bulbs while they are hot.
Halogen bulbs have pressurized gas inside and
require special handling. They can burst or shatter if
scratched or dropped. Hold a bulb only by its plastic
or metal case. Do not touch the glass part of a bulb
with bare hands.
NOTICE
Only use a bulb of the listed type.
To Next Page
Loading...
