Need help?Do you have a question about the Leybold vacuum TURBOTRONIK NT 10 and is the answer not in the manual?
General| Brand | Leybold vacuum |
|---|---|
| Model | TURBOTRONIK NT 10 |
| Category | Media Converter |
| Language | English |
Defines qualified personnel for operating the equipment and lists proper use guidelines.
Explains the meaning of 'Caution' and 'Warning' notices within the manual for safety.
Describes the purpose, differences, operating statuses, and outputs of the TURBOTRONIK frequency converters.
Details the housing, front, and rear panel features of the TURBOTRONIK NT10.
Details the housing and panel features of the TURBOTRONIK NT12.
Details the housing and panel features of the TURBOTRONIK NT13 with pressure trigger.
Lists technical specifications such as supply voltage, frequency, power consumption, and dimensions.
Details the included accessories and components for each TURBOTRONIK model.
Lists available accessories and their corresponding catalog numbers.
Details supply voltage range, relay assignment, and resonance monitoring for NT10.
Provides instructions for desktop and rack installation of the TURBOTRONIK NT10.
Explains how to connect power, TURBOVAC, and relay contacts for the NT10.
Describes different operating modes and remote control options for the NT10.
Outlines how to start and stop the TURBOVAC using the operator controls.
Details supply voltage range, relay assignment, and resonance monitoring for NT12.
Provides instructions for mounting the TURBOTRONIK NT12.
Explains how to connect power, TURBOVAC, and relay contacts for the NT12.
Describes different operating modes and remote control options for the NT12.
Outlines how to start and stop the TURBOVAC using the operator controls.
Details supply voltage range, relay assignment, and resonance monitoring for NT13.
Provides instructions for rack mounting the TURBOTRONIK NT13.
Explains how to connect power, TURBOVAC, and relay contacts for the NT13.
Describes operating modes and remote control for the NT13.
Outlines how to start and stop the TURBOVAC using operator controls.
Instructions on how to change the unit's input supply voltage range.
Procedures for removing and re-installing PC boards to access jumpers for configuration.
Identifies locations of jumpers, switches, and connectors on the PC board layouts.
Details the operating status of relays K1 and K2 for different functions.
Explains how to configure relay K1 for normal operation or pressure trigger functions.
Explains how to configure relay K2 for fault indication or pre-vacuum pump control.
Instructions on enabling or disabling the resonance monitoring function.
Describes the function of jumper field S2 for control inputs.
Details how to measure motor frequency using specific jumpers and connections.
Provides circuit examples for various remote control configurations.
Lists possible causes and counter-measures for the 'Power' LED not illuminating.
Troubleshooting steps for 'ACCEL' and 'NORMAL' LEDs not lighting up after acceleration.
Addresses issues when the 'FAIL' LED is active and TURBOVAC speed drops.
Troubleshooting when the 'FAIL' LED is active but TURBOVAC fails to start.
Diagnosing issues when the pump runs but fails to reach the adequate final pressure.
To Next Page
