Leybold vacuum TURBOTRONIK NT 12

Need help?

Do you have a question about the Leybold vacuum TURBOTRONIK NT 12 and is the answer not in the manual?

Summary

Description

1.1 Function of Design

Explains the purpose and basic operation of the TURBOTRONIK frequency converters.

1.2 Technical Data

Provides key technical specifications, ratings, and environmental data for the units.

TURBOTRONIK NT10 Connection and Operation

2.1 Equipment Configuration

Covers initial setup options like supply voltage and relay assignments for NT10.

2.1.1 Supply Voltage Range

Specifies the acceptable input voltage ranges for the TURBOTRONIK NT10.

2.2 Installing TURBOTRONIK

2.3 Electrical Connection

Details the procedures for making electrical connections to the NT10 unit.

2.4 Operating Modes; Remote Control

Explains the different operating modes and remote control options for the NT10.

2.5 Operator Control

TURBOTRONIK NT12 Connection and Operation

3.1 Equipment Configuration

Covers initial setup options like supply voltage and relay assignments for NT12.

3.1.1 Supply Voltage Range

3.2 Installing TURBOTRONIK

3.3 Electrical Connection

Details the procedures for making electrical connections to the NT12 unit.

3.4 Operating Modes;Remote Control

Explains the different operating modes and remote control options for the NT12.

3.5 Operator Control

TURBOTRONIK NT13 Connection and Operation

4.1 Equipment Configuration

Covers initial setup options like supply voltage and relay assignments for NT13.

4.1.1 Supply Voltage Range

4.2 Installing TURBOTRONIK

4.3 Electrical Connection

Details the procedures for making electrical connections to the NT13 unit.

4.4 Operating Modes;Remote Control

Explains the operating modes and remote control options for the NT13.

4.5 Operator Control

Setting the Equipment Configuration

5.1 Selecting the Supply Voltage Range

Procedure for changing the unit's selectable supply voltage range.

5.2 Withdrawing the PC Boards

5.3 Locations of Plug-ins and Jumpers

5.5 Setting the Configuration of Relay K1

5.6 Setting the Configuration of Relay K2

5.7 Setting the Resonance Monitoring Function

5.9 Measuring the Motor Frequency

5.10 Connecting Examples for Remote Control

Troubleshooting

6.1 Power LED Not Lit

6.2 ACCEL; NORMAL LED Issues

6.3 FAIL LED and Speed Drop

Addresses faults indicated by the 'FAIL' LED accompanied by speed reduction.

6.4 FAIL LED Without Run-up

Troubleshooting when the 'FAIL' LED is active but the pump does not start.

6.5 Normal Operation, No Final Pressure