31
Press the 【 LIGHT/SNOOZE】 button on top of the display console to silence the
alarm, or it will automatically turn off after one minute.
With DC Adapter
The backlight can only be continuously on when the DC adapter is permanently on. When the
DC adapter is disconnected, the backlight can be temporarily turned on.
Press 【 LIGHT/SNOOZE】button to adjust the backlight brightness, High, Low and Off.
Without DC Adapter
Press 【 LIGHT/SNOOZE】button temporarily turn on the backlight for 15 seconds.
18
18
18
To Silence the Hi/Lo Alert Alarm
NOTE: Once the alert is triggered, the alarm will sound for one minute and the associated
alert icon and weather readings will flash.
If the alert alarm automatically shuts off after one minute instead of being manually shut
off, the associated alert icon and readings will continue flashing until the reading is out of
the alert range.
The weather alert alarm will go off once the readings fall into alert range again.
BACKLIGHT
Display Backlight
FACTORY RESTART
If there is malfunction, the Factory Restart is a great way to return your station to
"out of the box" condition.
1.)
2.)
Remove all power (batteries and DC adapter) from outdoor sensors and weather station.
Follow the operation “SETTING UP THE WEATHER STATION” to start the pair the sensor.
If the low battery indicator icon is displayed in the outdoor temperature and humidity
section or the corresponding CH section of the LCD console display, this indicates that the
batteries in your wireless weather sensor(s) are running low and should be replaced. Make
sure to replace all batteries at the same time.
LOW BATTERY INDICATOR
To Next Page
Loading...
