LG 24MN42A-PT - Specification

- 6 -
LGE Internal Use OnlyCopyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
SPECIFICATION
NOTE : Specifications and others are subject to change without notice for improvement .
1. Application range
This spec sheet is applied to the TV used LM93B chassis.
2. Requirement for Test
Each part is tested as below without special appointment.
1) Temperature: 25 °C ± 5 °C(77 °F ± 9 °F), CST: 40 °C ± 5 °C
2) Relative Humidity: 65 % ± 10 %
3) Power Voltage
: Standard input voltage (AC 100-240 V~, 50/60 Hz)
* Standard Voltage of each products is marked by models.
4) Specification and performance of each parts are followed
each drawing and specification by part number in
accordance with BOM.
5) The receiver must be operated for about 5 minutes prior to
the adjustment.
3. Test method
1) Performance: LGE TV test method followed
2) Demanded other specification
- Safety : CE, IEC specification
- EMC : CE, IEC
4. General Specification
4.1. RGB-PC
No. Item Specication Remarks
1 Supported Sync. Type Separate Sync.(RGB), SOG
2 Operating Frequency Analog
Horizontal 30 ~ 69 kHz
Vertical 56 ~ 61 Hz
3 Operating Frequency Analog
Max 1366×768 @ 60Hz
Recommend 1366×768 @ 60Hz
4 Input Voltage Voltage :100 – 240 Vac, 50 or 60 Hz
5 Inrush Current Cold Start : 50 A, Hot : 120 A
6
Operating Condition Sync (H/V) Video LED Wattage
Power S/W On
On mode
On/On Active
Off
50(Max)
On/On Active 30(Typ.)
Sleep mode
Off/On
Off Blanking 1W RGB
On/Off
Power S/W Off Off mode - Off Red 0.5W
Just operate power key and remote
controller power button.
7 MTBF 30,000 HRS with 90 % Condence level Lamp Life : 30,000 Hours(min)
8 Using Altitude 5,000 m (for Reliability) 3,000m(for FOS)
9 Operating Environment
Temp : 10 °C ~ 35 °C
Humidity : 20 % ~ 80 %
10 Storage Environment
Temp : -10 °C ~ 60 °C non condensing
Humidity : 5 % ~ 90 % non condensing