APPENDIX
86
APPENDIX
PROGRAMMING THE REMOTE CONTROL
(This feature is not available for all models.)
Programming a code into a remote mode
Testing your remote control.
To find out whether your remote control can operate other components without programming, turn on a
component such as a VCR and press the corresponding mode button (such as a
DDVVDD
or
SSTTBB
) on the
remote control, while pointing at the component. Test the
PPOOWWEERR
and
CCHH
//
buttons to see if the
component responds correctly. If the component does not operate correctly, the remote control requires
programming to operate the device.
Switch on the component to be programmed, then press the corresponding mode button (such as a
DDVVDD
or or
SSTTBB
) on the remote control. The remote control button of the desired device is illumintated.
Press the
MMEENNUU
and
MMUUTTEE
buttons simultaneously, the remote control is ready to be programmed with
the code.
Enter a code number using the number buttons on the remote control. Programming code numbers for the
corresponding component can be found on the following pages. If the code is correct, the device will turn
off.
Press the
MMEENNUU
button to store the code.
Test the remote control functions to see if the component responds correctly. If not, repeat from step 2.
The remote control is a multi brand or universal remote. It can be programmed to operate most remote
controlled devices from other manufacturers.
Note that the remote control may not control all models from other brands.
1
2
3
4
5
6
MFL41469207en-Edit2 8/22/08 8:55 AM Page 86
To Next Page
Loading...
