LG 32LD310H - Page 43

43
206-4177
This section describes how you can reset a TV that is currently in FTG Mode to Pass-through Mode. Note
that the reset to Pass-through Mode will also restore all factory default settings on the TV.
There are three options for resetting Pass-through Mode on TVs that are in FTG Mode. The rst and
second options enable you to reset a single TV to Pass-through Mode, while the third option enables you
to reset multiple TVs to Pass-through Mode at one time.
Note: Depending on the software version loaded on the TV, you may also be able to reset the TV to Pass-
through Mode by setting Installer Menu item 117 FACT DEFAULT to 1 to reload factory defaults. If you
access the Installer Menu, and you are able to use the Up/Down arrow keys on the Installer Remote to
change the FACT DEFAULT value to 1, you may use this option to reset the TV.
• A predened value for Installer Menu item 117 FACT DEFAULT enables access to initiate a factory “IN-
STOP” process that will reset the TV to Pass-through Mode. Contact technical support for the required
value for Installer Menu item 117 and for additional information on performing the IN-STOP from the
Installer Menu.
• Using a USB memory device, “Teach” an FMA Conguration le that only contains a “0 Mapped
Channels” FTG Channel Map to the TV. Refer to “Creating an FMA Conguration File using the FTG
Conguration Application” and “Teaching FMA Conguration to a TV” on pages 30 and 31, respectively,
for further information.
• If your system uses a Pro:Centric server for conguration, use the Pro:Centric Admin Client to load an
FMA Conguration le that only contains a “0 Mapped Channels” FTG Channel Map on the Pro:Centric
server. Refer to the Pro:Centric™ Server Admin Client User Guide for further information.
Reference: Resetting a TV to Pass-through Mode