LG 32LT570H - Page 17

17
206-4340
Manual Pro:Centric Conguration
1. With the Searching for Pro:Centric Server screen on display, use the Left/Right arrow keys on
the Installer Remote to select Manual Pro:Centric at the bottom right of the screen, and then
press OK.
In the Pro:Centric Manual Conguration screen (see examples below), you will be able to
congure the appropriate Pro:Centric settings in the TV. Use the Up/Down arrow keys on the
Installer Remote to navigate between elds.
2. In the Pro:Centric Mode eld, use the Left/Right arrow keys to select the appropriate Pro:Centric
Application Mode—GEM (Java) or Conguration Only.
Note: For remote management only, select Conguration Only. The TV will search for TV
E-Z Installation data downloads; however, Pro:Centric application data will not be downloaded,
i.e., Installer Menu item 098 PRO:CENTRIC will be set to 0.
EZ-Manager Wizard
Pro:Centric Mode
Media Type
Data Channel
Signal Strength
Signal Quality
RF
<
Configuration Only
>
Back
Next
Exit
Pro:Centric Manual Configuration
0%
0%
No signal
1
4
3
2
1
Pro:Centric Manual Configuration Screen
with RF Media Fields
Note: By default, the Pro:Centric Manual
Conguration screen initially shows RF
conguration elds.
EZ-Manager Wizard
Pro:Centric Mode
Media Type
Address
Port
Configuration Only
IP
< >
Back
Next
Exit
Pro:Centric Manual Configuration
255
0
255255255
4
3
2
1
Pro:Centric Manual Configuration Screen
with IP Media Fields
3. Refer to the appropriate subsection below, depending on the Pro:Centric server conguration,
to complete the remaining elds.
RF Conguration
a) In the Media Type eld, use the Left/Right arrow keys to select RF.
b) In the Data Channel eld, either key in or use the Left/Right arrow keys to select the RF
channel number that will be used by the Pro:Centric server as its data channel. The Data
Channel value can be set from 1 to 135. *
EZ-Manager Wizard (Cont.)
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
(Continued on next page)