LG 32LT570H - USB Configuration

18
206-4340
EZ-Manager Wizard (Cont.)
(Continued from previous page)
IP Conguration
a) In the Media Type eld, use the Left/Right arrow keys to select IP.
Note: When you select “IP” as the Media Type, the default (RF) Data Channel and Signal
Strength/Quality elds are replaced with (IP) Address and Port elds.
b) In the Address and Port elds, either key in or use the Left/Right arrow keys to select the
appropriate values for the Pro:Centric server IP address and port number. The IP address
must match the IPv4 multicast address and the port number must match the port number
that is set in the Pro:Centric server.
4. Once all elds are completed as required, you have two options:
• To save the data entered and exit the wizard, use the arrow keys to select Exit and then press
OK. In the subsequent pop-up conrmation window, select Save and Exit, and then press OK
once more. The Pro:Centric application and/or E-Z Installation data will be downloaded to the
TV at a later time. This option is useful, in particular, if the Pro:Centric server has not yet been
congured.
• To initiate a real-time download of Pro:Centric application and/or E-Z Installation data, use the
arrow keys to select Next, and then press OK (see also note below).
Note: With RF conguration, Pro:Centric server data must be present on the RF channel
selected as the TV’s Data Channel in order for you to select “Next” (you will see a “Data
Channel Found” message below the Signal Quality indicator). With IP conguration,
Pro:Centric server data must be present via the wired LAN cable connection in order for
you to select “Next” (you will see a “IP Server Found” message below the Port eld).
If you opt to initiate a real-time download in the last step, the EZ-Manager Wizard will proceed with
the Pro:Centric application and/or E-Z Installation data downloads (see Processing the Pro:Centric
Conguration screen example on page 16). When the Pro:Centric conguration is complete, an
EZ-Manager Conguration Complete screen (see example on page 16) is displayed, and after
10 seconds, the wizard exits, and the TV turns OFF.
Note: With the EZ-Manager Conguration Complete screen on display, you also have the option
to manually turn off or reboot the TV. If desired, select Turn Off or Reboot, respectively, and then
press OK on the Installer Remote.
USB Conguration
TV Manager / USB download options enable you to download conguration, boot logo (splash
screen) image, or software les individually from a USB memory device to the TV. You can also use
the Ez Download utility available from the menu to select multiple types of les to be downloaded
at one time using one process.
Each of the USB download functions requires that you have the appropriate le(s) loaded on a USB
memory device. If you wish to perform a software update or download a boot logo, the software/
image le(s) must be stored in a folder named “LG_DTV” in the root directory of the USB device.
Clone/Conguration (.tlx) les should simply be stored in the root directory of the USB device.
The procedure below assumes that the desired le(s) is/are already loaded onto the USB device.
For further information on TV Manager / USB download options and le requirements, and/or for
information on creating Clone/Conguration (.tlx) les, refer to the appropriate section(s) in this
document.