LG 32LT570H - Page 52

52
206-4340
IP Environment Setup (Cont.)
(Continued from previous page)
By default, the TV uses DHCP, and if a LAN is detected, the TV
will request an IP address from the DHCP server on the network
as soon as you select START CONNECTION. If the TV is able to
connect to the network, a “Wired network is connected” message
will appear at the top of the next Network Setting window.
• If no further network conguration is required, use the arrow
keys on the Installer Remote to select CLOSE and press OK
to return to the IP Environment Menu.
• Otherwise, continue with step 5.
5. If the network is not congured for DHCP or you want to specify
static IP conguration data or you would like to change the
network conguration from Manual to Automatic, use the arrow
keys on the Installer Remote to select SET EXPERT from the
second Network Setting window, and then press OK. Then, edit
the IP data for this TV as follows:
Note: Use the arrow keys to navigate between elds.
• In the next Network Setting window, start by selecting the
desired mode—IP Auto Setting (default) or IP Manual Seting.
• To manually edit the IP data, use the arrow keys on the
Installer Remote to select each data entry eld and press OK.
Then, use the number keys on the Installer Remote to key in
the appropriate conguration data.
• When all elds are set as required, use the arrow keys on
the Installer Remote to select OK at the bottom right of the
window and press OK.
Note: You can specify a static DNS server with an auto-
congured IP address but not vice versa.
The TV will attempt to connect to the network and you will see
a progress display that indicates status as each network element
is conrmed. When the network is connected successfully, a
“Wired network is connected” message will be displayed at the
top of the window, along with the network conguration data
(see example under “Network Status” below).
6. Select COMPLETE (if not already selected), and then press OK
on the Installer Remote to return to the IP Environment Menu.
Note: If the network connection is not successful, the progress
screen will identify the network element in which the connection
failed. Check your cabling and/or, if necessary, press
on the
Installer Remote to verify the conguration data.
NETWORK SETTING
Wired network is connected.
For detailed settings, select [Set Expert].
SET EXPERT
PREV.
CLOSE
NETWORK SETTING
Setting your network will enable network-related features on the TV.
Connect a LAN cable to the back of TV.
START CONNECTION
PREV.
CLOSE
NETWORK SETTING
Select the IP setting mode.
^
^
IPv4
IP Auto Setting
IP Address
Subnet Mask
Gateway
DNS Auto Setting
DNS Server
^
^
0
255
0
255
0
0
0
0
0
0
0
0
0
0
0
0
CLOSE
^
^
OK