LG 32LT570H - Page 65

65
206-4340
Reference: FTG Mode via EBL (Local Conguration) (Cont.)
(Continued from previous page)
5. “Write” the FTG Channel Map to the EBL (switches the EBL from Pass-through Mode to FTG Mode).
Note: After a “Write” of new data, the TV will briey display a green text banner that shows the EBL
rmware version and release date.
6. “Read” the current FTG Installer Menu settings from the EBL using the FTG Installer Menu
Conguration Utility. If necessary to make changes to Installer Menu items, “Write” them back to the
EBL in FTG Mode.
Note: When you “Read” the settings from the EBL, a pop-up notice will be displayed (see example
below) to indicate that the chassis ID of this model is unknown and so a generic Installer Menu prole
will be loaded. Click OK to dismiss the pop-up window and continue. The resulting “generic” prole
contains all Installer Menu items, including a number of items that may not be applicable for this model.
Refer to the Installer Menu section of this document for detailed information on Installer Menu items
that are specic to the LT570H, and make any changes necessary.
7. Save the FTG Channel Map and FTG Installer Menu settings to an FTG Conguration (.rml) le for
future use.
8. Tune the TV to a logical channel in the FTG Channel Map.