Sync Mode
This feature allows you to sync the start times of contents (videos or images that have been distributed by
SuperSign Software) played back on the Master and Slave monitors.
If you set Sync Mode to Off, the sync feature is disabled.
A Slave monitor plays contents at the same time as the Master monitor.
While Sync Mode is performed, RS-232C control of other commands may not work.
(This feature may not be available with some models.)
Sync Mode
(Only for SE3C models.)
The Sync feature is used to start playing content (video or image) distributed by Elite-W across multiple
monitors connected via RS-232C at the same time.
If set to Off, the Sync feature is disabled.
If set to Master for a monitor, the monitor is set as the reference monitor.
If set to Slave for a monitor, the monitor plays content at the same time as the Master monitor.
DPM Wakeup Control
This feature sets conditions for releasing the DPM status according to the DVI/HDMI's processing of digital
signals.
Clock: Checks the clock signal of the digital signal and, if the clock signal exists, releases the DPM status.
Sync: Releases the DPM status when both the clock signal and data of the digital signal are entered.
Still Image Detecting
This feature detects still images.
If you set this feature to Yes, you can use the RS-232C command for detecting still images.
PM Mode
This feature activates some of the monitor's functions after it enters Off status, allowing the monitor to remain
practically the same as when it is turned on.
Power Off: All functions remain turned off except some functions (Power, Time, etc.) when the monitor turns
off. (Extended Display Identification Data (EDID) may be sustained depending on the input and
model.)
Sustain Aspect Ratio: Sustains Extended Display Identification Data (EDID) even when the monitor is turned off.
Screen Off: Only turns off the screen and audio when the monitor enters Auto Off/Automatic Standby/DPM.
Network-based control is possible.
Screen Off Always: Has the same function as PM Mode's Screen Off. Entering and releasing the Screen Off status
using a remote control is also possible.
To Next Page
Loading...
Need help?
General
