LG Digital Signage Setup
Initial setting/
Factory Reset
Signage Mode Opera-
tion
Signage Mode Operation Yes/No No Yes No
Power On Status STD/PWR/LST LST User LST
Key Operation Yes/No No User No
IR Operation Normal/Use PWR Only/Block All Normal User Normal
Local Key Operation Normal/Use PWR Only/Block All Normal User Normal
Limited Mode Yes/No No User No
Input Source Change Yes/No Yes User Yes
Menu Display Yes/No Yes User Yes
OSD Display Yes/No Yes User Yes
Power On Default Yes/No No User No
Input Source O/RGB/HDMI/DVI-D /OPS O User O
A/V Settings Yes/No No User No
Aspect Ratio Disable/Set By Program/4:3/16:9 Disable User Disable
Wake On LAN On/O O User O
DPM O/ 5sec./ 10sec./ 15sec./ 1min./
3min./ 5min./ 10min.
10min. User 10min.
Digital Audio Input Analog/Digital Digital
(RGB: Analog)
User Digital
(RGB: Analog)
Speaker On/O On User On
Power On Delay O, 1 - 250 sec O User O
Pivot mode On/O O User User
OSD Portrait Mode O/90/270 O User O
Intelligent Auto On/O On User On
Master/Slave Mode Master/Slave Slave User Slave
Time Sync Clock O / Stand-by / 0:00 - 23:00 Stand-by User Stand-by
Sync Mode On/O O User O
DPM Wakeup Control Clock/Sync Clock User Clock
Still Image Detecting Yes/No Yes User User
PM Mode Power O/Sustain Aspect Ratio/
Screen O/Screen O Always
Power O User Power O
Factory Reset Conrm
OPS/PC Power Control
Disable, Sync(On), Sync(On/Off)
Disable User Disable
Interface Selection RS-232C/OPS RS-232C User RS-232C
Check Screen Off/On Off User Off
** User: User settings
Factory Reset vs. Initial Setting
Item Factory Reset Initial Setting
Set ID User 1
IP User Reset to default value "0"
** The rest are the same as each other.
To Next Page
Loading...
Need help?
General
