EasyManuals Logo

LG 43UH5F User Manual

LG 43UH5F
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
ENGLISH
52
Picture ID
[Picture ID] is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
monitor is identified by a Set ID. Setting [Picture ID] allows you to only use the remote control with monitors with a
[Set ID] that matches the [Picture ID].
1 Assign [Set ID] to the installed monitors as shown below:
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
2
Press the red [Picture ID] [On] button on the remote control.
3
Make sure that the Picture ID you set is identical to the [Set ID] of the monitory you wish to control.
A set with a [Set ID] that is different from the [Picture ID] cannot be controlled by IR signals.
NOTE
If [Picture ID] has been set to 2, only the upper right monitor, which has a [Set ID] of 2, can be controlled by IR signals.
If you press the green [Picture ID] [Off] button on your remote control, the [Picture ID] for all monitors are turned
off. If you then press any button on the remote control, all monitors can be controlled by IR signals regardless of their
[Set ID]'s.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG 43UH5F and is the answer not in the manual?

LG 43UH5F Specifications

General IconGeneral
Panel life50000 h
Response time8 ms
Display diagonal43 \
Display brightness500 cd/m²
Display technologyIPS
Native aspect ratio16:9
Contrast ratio (typical)1100:1
Display diagonal (metric)108 cm
HDMI ports quantity3
DVI-D ports quantity1
VGA (D-Sub) input ports0
OrientationHorizontal/Vertical
Product colorBlack
Product designDigital signage flat panel
Bezel width (top)8.4 mm
Placement supportedIndoor
Bezel width (bottom)14.4 mm
Panel mounting interface200 x 200 mm
PurposeUniversal
TV tuner integrated-
Operating hours (hours/days)24/7
International Protection (IP) codeIP5X
Computer system typeSystem on Chip (SoC)
Operating system installedWeb OS
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 80 %
Cables includedAC, HDMI, RS-232
Tilt angle range0 - 30 °
Sustainability certificatesENERGY STAR
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Energy efficiency scaleA to G
Power consumption (standby)0.5 W
Power consumption (typical)70 W
Package depth152 mm
Package width1052 mm
Package height660 mm
Package weight13700 g
Weight and Dimensions IconWeight and Dimensions
Depth39.9 mm
Width962.5 mm
Height568 mm
Weight11200 g

Related product manuals