27
ASSEMBLING AND PREPARING
3
M4 x L14
8 EA
4
Stand cover
Insert the protruding parts of the Stand cover into
the holes.
CAUTION
5
Cover holder
Stand
cover
Insert the Cover holder of the Stand cover into the
holes until it clicks.
CAUTION
Remove the stand before installing the TV on a
wall mount by performing the stand attachment in
reverse.
NOTE
When attaching the stand to the TV set, place the
screen facing down on a cushioned table or flat
surface to protect the screen from scratches.
Make sure that the screws are inserted correctly
and fastened securely. (If they are not fastened
securely enough, the TV may tilt forward after being
installed.)
Do not use too much force and over tighten the
screws; otherwise screw may be damaged and not
tighten correctly.
CAUTION
To Next Page
Loading...
