LG 55LS675H - Pro:centric Manual Configuration

12
206-4213
Automated Installation Routine Wizard (Cont.)
Pro:Centric Manual Conguration
If you already know the settings (i.e., Data Channel and Pro:Centric Application Mode) that need to
be congured in order for the TV to connect to the Pro:Centric server, you may streamline the setup
process by entering this data manually.
1. Use the Up/Down arrow keys on the Installer Remote to select/highlight Pro:Centric Manual
from the Automated Installation Routine Wizard Welcome screen. Then, press OK.
In the rst Manual Conguration Screen (see example below), you will be able to congure
the appropriate Pro:Centric settings. Use the Up/Down arrow keys on the Installer Remote to
navigate between elds.
Note: Select the “Back” button from the Manual Conguration screen or press the key on the
Installer Remote, if desired, to return to the Welcome screen.
Manual Configuration
Pro:Centric Mode
Channel Number
Signal Strength
0%
GEM
1
< >
BACK
NEXT
Save and Exit
OK
Move
Prev.
Manual Configuration
Processing Pro:Centric Configuration.
Step 4 may take up to 5 min(s).
Please wait...
Step 1 Detecting the type of Pro:Centric network
Step 2 Locating the Pro:Centric Server
Step 3 Determining the Pro:Centric mode
Step 4 Downloading the application files
Step 5 Downloading the maintenance files
Step 6 Saving the Pro:Centric configuration
Warning - Do not remove AC power or the signal cables during these steps
50%
RF
DIGITAL 75
GEM
In Progress
:
:
:
:
:
:
Prev.
2. In the Pro:Centric Mode eld, use the Left/Right arrow keys to
select the appropriate Pro:Centric Application Mode—GEM,
FLASH, or Conguration Only.
Note: For remote management only, select the Pro:Centric
Mode “Conguration Only” option to search for TV E-Z
Installation data downloads. Pro:Centric application data will
not be downloaded.
3. In the Channel Number eld, either key in or use the Left/
Right arrow keys to select the RF channel number for the
Data Channel of the Pro:Centric server. The Data Channel
can be set from 1 to 135.
4. Once all elds are completed as required, you may have two
options (see also note below):
• To save the data entered and exit the wizard, use the
arrow keys to select Save and Exit, and then press OK.
The Pro:Centric application and/or E-Z Installation data
will be downloaded to the TV at a later time. This option is
useful, in particular, if the Pro:Centric server has not yet
been congured.
• To initiate a real-time download of Pro:Centric application
and/or E-Z Installation data, use the arrow keys to select
Next, and then press OK.
The Pro:Centric Manual Conguration will proceed with
the remaining Pro:Centric application and/or E-Z Installa-
tion data download steps, as shown on the second Manual
Conguration screen (see example at right). When the
Pro:Centric Manual Conguration is complete, the wizard
exits, and the TV will turn OFF.
Note: The RF signal must be detected on the Data Channel
of the Pro:Centric server in order for you to select “Next” (you
will see a “Data Channel found” message below the signal
strength indicator).