LG 55UH65 Series - Open Source Software Notice Information; External Control Device Setup

ENGLISH
23
Registering magic remote
How to register the magic
remote
To use the Magic Remote, rst pair it with your TV.
1 Put batteries into the Magic Remote and
turn the TV on.
2 Point the Magic Remote at your TV and press
the Wheel (OK) on the remote control.
* If the TV fails to register the Magic Remote,
try again after turning the TV off and back
on.
How to deregister the magic
remote
Press and hold the and (HOME)
buttons at the same time for ve seconds, to
unpair the Magic Remote with your TV.
* Pressing and holding the button will
let you cancel and re-register Magic Remote
at once.
Licenses
Supported licenses may dier by model. For
more information about licenses, visit www.
lg.com.
(Only UH95**,
UH85**, UH77**,
75UH78**, 70UH70**)
Open source
software notice
information
To obtain the source code under GPL, LGPL, MPL
and other open source licenses, that is contained
in this product, please visit http://opensource.
lge.com.
In addition to the source code, all referred
license terms, warranty disclaimers and
copyright notices are available for download.
LG Electronics will also provide open source code
to you on CD-ROM for a charge covering the cost
of performing such distribution (such as the cost
of media, shipping, and handling) upon email
request to opensource@lge.com. This oer is
valid for three (3) years from the date on which
you purchased the product.
External control
device setup
To obtain the external control device setup
information, please visit www.lg.com.