LG 65EW960H.AUS - User Manual

Questions and Answers:

T
Tracey HammondAug 12, 2025
Why is my LG 65EW960H.AUS remote not working?
- H
  heatherlongAug 12, 2025
  If the remote for your LG TV isn't working, first ensure that it is set to TV mode using the MODE key. Point the remote directly at the IR receiver on the TV, and make sure you are close enough, without obstructions in the path. Replace the batteries, making sure they are inserted with the correct polarity (+ and -). Dim the room light, as too much light can interfere with the signal. If none of these steps work, you may need a compatible LG Installer Remote; contact your LG representative.
R
Robert TurnerAug 19, 2025
What to do if there is no picture on my LG 65EW960H.AUS?
- J
  juliaryanAug 19, 2025
  If your LG TV screen is blank, ensure that the TV is turned on and check for any power failures. Verify that the antenna or cable is correctly connected to the TV. Also, inspect all connections to ensure they are properly set up. If applicable, make sure the MPI cable is connected to the MPI device. If the channel is encrypted, try tuning to a different channel. Finally, adjust the installer menu settings to ensure the correct tuning band is selected.
J
jeremy08Aug 27, 2025
What to do if my LG 65EW960H.AUS TV has normal picture but no sound?
- J
  jameswilliamsAug 27, 2025
  If your LG TV has a picture but no sound, first ensure the audio isn't muted by pressing the MUTE button or using the Volume Up key. If that doesn't work, the problem might be with the broadcast itself, so try changing to a different channel.
A
allisonlongSep 3, 2025
Why can't I enter channel numbers directly on my LG TV?
- K
  Kim LeachSep 3, 2025
  If you cannot directly enter a channel number on your LG TV, it might be because the TV is in Pass-through Mode and the 'CH. OVERIDE' setting in the Installer Menu is disabled. To enable direct keypad entry, set 'CH. OVERIDE' to 1. Alternatively, if the TV is not in Pass-through Mode, the channel you are trying to enter may not be included in the current Channel Map. In this case, modify the Channel Map using the appropriate application or content editor.