• Insert the nuts and washer into the suspension bolts
for locking the suspension bolts on the ceiling.
• Mount the suspension bolts to the anchor-nuts firmly.
• Secure the Installation plates on Suspension bolts
(adjust level roughly.) using nuts, washers and spring
washers.
• Engage 2 hooks on both left and right side of the unit
to the lower slot of Installation Plates.
• Adjust a level with a level gauge on the direction of
left-right, back-forth by adjusting suspension bolts.
• Move the hooks on the unit to the upper slot of
Installation Plates. Then the unit will be declined to the
bottomside so as to drain well.
To Next Page
Loading...