3. TECHNICAL BRIEF
- 17 -
B. OPLL
The OPLL consists of a feedback mixer, a phase detector, a loop filter, and a fully integrated
TXVCO. The TXVCO is centered between the DCS 1800 and PCS 1900 bands, and its output is
divided by 2 for the GSM 850 and E-GSM 900 bands. The RFLO frequency is generated
between 1272 and 1483 MHz. To allow a single VCO to be used for the RFLO, high-side injec-
tion is used for the GSM 850 and E-GSM 900 bands, and low-side injection is used for the DCS
1800 and PCS 1900 bands. The I and Q signals are automatically swapped when switching
bands. Additionally, the SWAP bit in register 03h can be used to manually exchange the I and
Qsignals.
Low-pass filters before the OPLL phase detector reduce the harmonic content of the quadra-
turemodulator and feedback mixer outputs. The cutoff frequency of the filters is programmable
with the FIF[3:0] bits in register 04h (Figure 3-3), and should be set to the recommended settings
detailed in the register description.
To Next Page
Loading...
Need help?
General
