Operation 9
•This function will be operated when portable device connect to PORT 1
in BP4 10400 mAh.
•When sequential charging function is operated, charging current will be
limited. Thus, it may take longer to charge.
•This function is recommended to use genuine charger. If you charge by
using USB port in PC, it may not be charged.
•If disconnecting the charger while charging portable device(product to
be charged) by using sequential charging, the portable device will be
charged.
•If disconnecting a portable device while charging portable device
(product to be charged) by using sequential charging, the portable
battery will be charged about 20 seconds later.
•If doing sequential charging within 20 seconds since the LED button has
been pressed, the portable battery will be charged after the portable
device is charged completely.
•If connecting the charger to the portable battery while charging a
portable device, the portable battery will be charged after the portable
device is charged completely.
•When you charge the portable device that the charging specication is
over 1A by using sequential charging, it might not be displayed charging
indication on your portable device.
,
Note
BP410_BP405_BP302_ENG_TAY35387870.indd 9 2014-04-30 �� 9:55:58
To Next Page
Loading...
