22 Air-to-Water Heat Pump
Owner's instruction
Programming : Sanitary tank heating & Sanitary tank heater operation
This function is schedule programming about sanitary tank heating and sanitary tank heater
operation. Two schedule programming for sanitary tank heating and another Two schedule
programming for sanitary tank heater operation are possible. Pre-assigned program numbers for
sanitary tank heating programming are ʻ1ʼ and ʻ2ʼ. Programming number ʻ3ʼ and ʻ4ʼ are assigned for
sanitary tank heater operation. Scheduled programming will be operated everyday.
1
Press programming button to enter the Programming mode. Repeat pressing button to
select Sanitary tankt heating programming. (the segment flashing)
2
Press left and right button to adjust schedule program number. Programming number ʻ1ʼ
and ʻ2ʼ are for sanitary tank heating programming(if selected, ʻSanitary tank heating
enabledʼ icon will be flashing), and ʻ3ʼ and ʻ4ʼ are for sanitary tank heater operation
programming(if selected, ʻSanitary tank heaterʼ icon will be flashing).
3
After selecting Programming number, press down button to enter adjusting turn-on time.
Turn-on time can be adjusted by pressing left, right, up, and down button. After assigning
minute of turn-on time, press right button to enter adjusting turn-off time. Like adjusting
turn-on time, press left, right, up, and down button to change turn-off time.
4
Press set button to finish programming.
To exit Programming mode, press ESC button.
To Next Page
Loading...
Need help?
General
