Additional Information
Specifications
Power Requirements
Refer to the main label on
the unit.
Power Consumption
Refer to the main label on
the unit.
Dimensions (W x H x D)
Approx. 450.0 mm x
167.0 mm x 332.0 mm
Bus Power Supply (USB)
5 V 0 500 mA
Amplier
(Total RMS output power)
2,900 W RMS
Design and specications are subject to change without
notice.
Replacement of battery
About Ferrite Core (Optional)
Wind power cord cable around the ferrite core twice.
Caution
y When you use the multiple socket, it is advisable to use
15 A socket. 10 A socket may cause power off due to
lack of power supply.
y Do not place objects on the speakers. It may cause the
objects to fall and make property damage.
y Install the speakers on a rm surface not to slide. The
vibration caused by the strong output can shake and
move the speakers.
y Avoid turning up max volume in a small enclosed space.
The powerful and intense output of the speakers can
shake the ceiling and get the objects in the room falling.
y To protect from hearing damage, keep the sufcient
distance from the speaker. The overwhelming sound
from the speaker may cause a person’s hearing damage.
y Allow more than 20 cm of free space between the
main set and the speakers when you install the main
set on the ground. High sound pressure from the
speakers can make the set vibrate which can disturb
the CD playback.
y Connect the power cord to wall outlet directly if
possible. Or when you use an extension cable, it is
highly recommended to use an extension cable of
110 V / 15 A or 230 V / 15 A, otherwise the unit may
not operate properly because of the lack of power
supply.
y Do not overload the extension cord with excessive
electrical load.
Note
y
Do not look directly at the light emitting part when the
LIGHTING is turned on.
y
If the illumination brightness is glaring, switch on the
room lights or turn off the LIGHTING of the unit.
POWER: This unit operates on a mains supply of
200 - 240 V ~ 50 / 60 Hz.
Wiring: This unit is supplied with a BS 1363 approved
main plug. When replacing the fuse, always use a fuse of
the same rating and approved to BS 1362. Never use this
plug with the fuse cover omitted. To obtain a replacement
fuse cover contact your dealer. If the type of plug supplied
is not suitable for the mains sockets in your home, then
the plug should be removed and a suitable type tted.
Please refer to the wiring instructions below:
Warning: A mains plug removed from the mains lead of
this unit must be destroyed. A mains plug with bared wires
is hazardous if inserted in a mains socket. Do not connect
either wire to the earth pin, marked with the letter E or
with the earth symbol
6
or coloured green or green and
yellow. If any other plug is tted, use same rating of fuse in
the plug.
Important: The wires in this mains lead are coloured in
accordance with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the
wires in the mains lead of this unit may not correspond
with the coloured marking identifying the terminals in your
plug, proceed as follows: The wire which is coloured blue
must be connected to the terminal which is marked with
the letter N or coloured black. The wire which is coloured
brown must be connected to the terminal which is marked
with the letter L or coloured red.
www.lg.com
Copyright © 2019 LG Electronics Inc. All Rights Reserved.
SIMPLE MANUAL
Mini Hi-Fi
System
Please read this manual carefully before operating your set and retain it for
future reference.
To view the instructions of advanced features, visit
http://www.lg.com and then download Owner’s Manual.
Some of the content in this manual may differ from your unit.
MODEL
CL88
1910_Rev01
ENGLISH
CL88-FB.DKENHLK_SIM (Sheet)_MFL71447108.indd 2 2019-10-23 12:08:53
To Next Page
Need help?
General
Weight and Dimensions
