To Next Page

To Previous Page

- 38 -

3.2 High Ceiling operation

Function Code Thermistor setting

Select ceiling height value by pressing button. (01:Low,

02:Medium, 03:High, 04:Very high)

Press button to save.

If moving to ceiling height selection menu by pressing button,

it indicates as picture below.

If pressing button long for 3 seconds, it enters into

remote controller setter setup mode.

- If pressing once shortly, it enters into user setup mode.

Please press more than 3 seconds for sure.

Pressing button will exit settings mode.

❈ After setup, it automatically gets out of setup mode if there is no button input

for 25 seconds.

❈ When exiting without pressing set button, the manipulated value is not

reflected.

This function is to adjust FAN Airflow rate according to ceiling height (For ceiling type product)

• Ceiling height setting is available only for some products.

• Ceiling height of ‘Very high’ function may not exist depending on the indoor unit.

• Refer to the product manual for more details.

Ceiling Height Level Description

01 Low Decrease the indoor airflow rate 1 step from standard level

02 Medium Set the indoor airflow rate as standard level

03 High Increase indoor airflow rate 1 step from standard level

04 Very high Increase indoor airflow rate 2 steps from standard level

Part 2 Functions & Controls

LG CM24F Service Manual

Other manuals for LG CM24F