Troubleshooting 25
Troubleshooting
4
Troubleshooting
General
Symptom Cause & Solution
No Power.
y
The power cord is not plugged in. Plug in the power cord.
y
Check whether electricity failed.
Check the condition by operating other electronic devices.
No sound.
y
Check whether you select right function.
Press FUNCTION and check the selected function.
y
If not, connect speaker cables correctly.
Speaker cables connected correctly.
The unit does not start
playback.
y
An unplayable disc is inserted. Check the playable disc.
y
No disc is inserted. Insert a disc.
y
The disc is dirty. Clean the disc. (Refer to the 29 page)
y
The disc is inserted upside down.
Place the disc with the label or printed side facing upwards.
Radio stations cannot
be tuned in properly.
y
The antenna is positioned or connected poorly.
Connect the antenna securely.
y
The signal strength of the radio station is too weak.
Tune to the station manually.
y
No stations have been preset or preset stations have been cleared (when
tuning by scanning preset channels).
Preset some radio stations, see page 19 for details.
The remote control
does not work properly.
y
The remote control is too far from the unit.
Operate the remote control within about 23 ft (7 m).
y
There is an obstacle in the path of the remote control and the unit.
y
Remove the obstacle.
y
The batteries in the remote control are exhausted.
Replace the batteries with new ones.
iPod does not work.
y
Check whether the player is connected to the unit correctly.
Connect it to the unit correctly.
Sub woofer does not
work.
y
Check whether the woofer is connected to the unit correctly.
Connect cables to the unit correctly. (Refer to the 12 page)
CM6520-AP_DKENHLK_ENG.indd 25 2012-05-02 3:55:25
To Next Page
Loading...
Need help?
General
