17
Cleaning the Power
Floor/Carpet Nozzle
Check the brush and roller heads before using and
clean as needed.
1
Remove the nozzle from the product. Press
the release button to remove the head from the
wand or product body.
2
Turn the head upside down and insert a at-
blade screwdriver in the cover lock slot. Rotate
the lock counterclockwise as shown to open the
cover.
Cover lock
3
Rotate the brush cover up and pull the brush
out.
①
②
4
Attach the crevice tool to the unit and use the
vacuum to remove dust/foreign objects from the
brush and the bottom of the nozzle.
Rotating
brush
5
Use a wet towel or tissue to remove any
remaining foreign matter and dust from the
brush and the bottom of the nozzle.
Rotating
brush
6
Slide the brush back into the head and rotate
the cover back into place. Turn the cover lock
clockwise to lock the cover.
①
②
CAUTION
•
Keep ngers away from pinch points when
removing and assembling the brush.
•
Do not immerse the brush or head in water or rinse
them in running water.
•
Do not pick up oils or liquids with the vacuum.
Cleaning the Bedding Power
Punch
1
Remove the Bedding Power Punch and turn it
upside down.
2
Attach the crevice tool to the unit and use the
vacuum to remove dust/foreign objects from the
bottom of the Bedding Power Punch.
3
Use a wet towel or tissue to move any remaining
foreign matter and dust.
WARNING
•
Do not immerse the Bedding Power Punch in water
or rinse it in running water.
•
Do not suck any liquids including water into the
Bedding Power Punch.
MFL69883611_en_180523.indd 17 2018-05-23 오후 12:26:37
To Next Page
Loading...
