What to do if LG CRD-8522B CD/CDR Drive is not present in Windows 3.1 or 3.11 or DOSSHELL?
If you find that your LG CD/CDR Drive is not present in Windows 3.1, 3.11, or DOSSHELL, ensure that the MSCDEX.EXE command line appears before the WIN or DOSSHELL command lines in your AUTOEXEC.BAT file.
Why my LG CRD-8522B does not work with the hard disk drive in primary IDE channel?
If your LG CD/CDR Drive isn't working with the hard disk drive in the primary IDE channel, consider the following: 1. Check the CD-ROM drive's Master/Slave Jumper setting and ensure it is set to Slave mode. 2. Verify that your hard disk interface type is IDE. 3. Examine your hard disk's Master/Slave Jumper setting. Some older IDE hard disks may be set to Master Only mode. If so, contact your hard disk manufacturer to change the jumper setting to master mode. 4. If the issue persists, you might need a secondary IDE card. If using one, set the CD-ROM drive jumper to master mode if it's the first device connected to the secondary IDE card.
Details the controls visible on the front panel of the CD-ROM drive.
Describes the connectors and jumpers located on the rear panel of the drive.
Step-by-step instructions for physically installing the CD-ROM drive into a computer system.
Common issues and solutions for CD-ROM drive installation and operation.
Information on the duration of the warranty and how to obtain service.
General| Brand | LG |
|---|---|
| Model | CRD-8522B |
| Category | CD/CDR Drive |
| Language | English |
To Next Page
